single in/out
----- Original Message -----
From: "Bernd D. Ratsch" <bernd@texas.net>
To: <dakota-truck@dakota-truck.net>
Sent: Saturday, August 23, 2003 10:10 AM
Subject: DML: RE: Re: RE: Cat question
>
> Dual IN/Single OUT or Single IN/OUT configuration on your truck?
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Chad Evans
> Sent: Saturday, August 23, 2003 9:45 AM
> To: dakota-truck@dakota-truck.net
> Subject: DML: Re: RE: Cat question
>
>
>
> bernd you have the part number for the carsound for my truck. 2.5 "
> would be good ?
>
>
> ----- Original Message -----
> From: "Bernd D. Ratsch" <bernd@texas.net>
> To: <dakota-truck@dakota-truck.net>
> Sent: Friday, August 22, 2003 8:48 PM
> Subject: DML: RE: Cat question
>
>
> >
> > Matt,
> >
> > If the Carsound cat doesn't have the fitting for the forward O2, you
> > can have any local muffler shop put an O2 bung right before the cat
> > (in the pipe).
> >
> > - Bernd
> >
> > -----Original Message-----
> > From: owner-dakota-truck@bent.twistedbits.net
> > [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Matt
> > Grose
> > Sent: Friday, August 22, 2003 7:23 PM
> > To: dakota-truck@dakota-truck.net
> > Subject: DML: Cat question
> >
> >
> >
> > My cat is very close to be totally shot and I want to replace it as
> > well as the entire exhaust system. I was under the truck today and
> > noticed that the
> > read O2 sensor is screwed into the cat. Will I need to drill a hole in
> > the
> > new cat for the O2 sensor? The new cat is a Car Sound Hi-Flow Cat I
> got
> > from Bernd's shop before it closed down. If I need to drill a hole
> what
> > size should it be? Sorry for the stupid question but I am fairly new
> to
> > doing mods to the truck. Mostly I have down bolt on's and nothing much
>
> > technical. Thanks in advance.
> >
> > -Matt Grose
> >
> >
> >
>
>
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:53 EST