On Tuesday, September 16, 2003, at 12:09 PM, Brian Mingle wrote:
> Can somebody on the list point me to a decent cat back system for a
> 1998 Extended Cab Short Box 4x4? Gibson has one for an extended cab
> short box, but it's for a 2wd. I am looking for a system that will
> pretty much bolt up, and not need a lot of fabricating. Is there such
> a thing?
I adore my magnaflow cat-back, but I'm thinking I would have been
better off with some other exit point than stock since the 4" tip has
caused me problems in it's placement a few times versus the stock 3"?
2.5"? exit. backing over high curbs will make it scrape, and it
smacked my quarter panel at the BBQ, I'd assume while backing off the
waterfall.
I think I need leg pipe rock sliders ;-P
the bottom of my list of to-dos is to fix that problem, and what I'm
probably going to do is copy what someone on dodgedakotas.com did, and
run out through the rocker panel in the club cab on the passenger side.
I'll probably need to find a more restrictive, smaller muffler,
especially with headers, in order to keep my low end when I do that
though, along with helping out the heat insulation on the bottom of the
cab.
I may end up rigging some protection for that quaterpanel though, in
case I smack it again before I get the exhaust moved....
-- Michael Maskalans <http://mike.tepidcola.com/> ClassTech Consultant - ITS Printer Tech - ITS Lab Tech mobile.612.618.4652 campus.585.274.2246 fax.954.697.0487
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:58 EST