Ron
And how exactly do you go about doing this, poke the needle into the rubber
boot or slip it in between the metal and rubber and just squirt a little
bit?
Thanks
Jay
----- Original Message -----
From: <slakie@cox.net>
To: <dakota-truck@dakota-truck.net>
Sent: December 17, 2003 1:16 PM
Subject: DML: Greasing of the Ball Joints
>
> After reading all these posts about a lack of zerks for the ball joints I
am wondering why more of you don't use a grease needle attachment on your
grease gun to keep the ball joints lubricated. I have been doing this for
years and the last set of ball joints I replaced were on a 73 Pinto. I have
used the needle attachment on my 84 Mazda RX 7 (original owner) and recently
on my 2K Dak with excellent results.
>
> Ron
> Springfield, VA
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:12 EST