Hi Jon,
Been a while. How you doin'? Yeah, I figure one day there will be a 9.25"
going in. I don't expect the stock one to last, and I know my wife will
give me grief when it goes. She'll say I was out hot-rodding around.
Imagine that!
Once I get the DAK back on the road, I'm going to look into getting an
aluminum driveshaft made up. No ideal what this would cost, so it may be
enough by itself to push the 9.25" rear right along with it.
Rich
-----Original Message-----
From: Jon Smith [mailto:jon@fast4x4.net]
Sent: Thursday, March 04, 2004 7:44 PM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: DML: Re: Re: Aluminum Driveshaft Question
R/T's have a different Ujoint yoke.. unless Rich wants to swap in a 9.25"
rear.. C'mon Rich!
-Jon S
CC R/Ts use a 1 piece from all I've seen.
TonyC
>
>Has anyone taken their CC and swapped out the 2-piece stock driveshaft
(with
>the intermediate bering) for a 1-piece aluminum shaft? Even for a 2-piece
>aluminum shaft? It seems there is an awlful lot of wasted energy with the
>stock arrangement.
>Rich - Ashburn,VA
>
This archive was generated by hypermail 2b29 : Sat Feb 16 2008 - 21:39:21 EST