RE: RE: O2 Simulator

From: Bernd D. Ratsch (fasstdak@hotmail.com)
Date: Sat Apr 03 2004 - 10:24:52 EST


As long as you supply power to the sensor...yes. But you really don't
want to use the O2 behind the cat for A/F readings. Install either a
heated (separate) O2 or a single-wire O2 for you're A/F gauge.

And do NOT use the factory wiring unless you like watching a light show
(and possibly off-setting the signal to the PCM). You can NOT tap into
the newer NGC O2 sensor harness as it's not the same voltage anymore
(2.5v-3.5v instead of 0-1v).

BTW: JTEC = Jeep Truck Engine Controller

- Bernd

-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of GMBlows
GMBlows
Sent: Saturday, April 03, 2004 9:14 AM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: RE: O2 Simulator

Can the cut sensor wire be used with an aftermarket A/F meter? Or does
that sensor not function like a typical O2 sensor?



This archive was generated by hypermail 2b29 : Sat May 01 2004 - 12:00:16 EDT