No I haven't but that option is open. It's that KRC is only an hour away so
It would be convenient to pick up my parts or visit him for some fine tuning
etc...
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Andy Levy
Sent: Saturday, October 02, 2004 9:29 AM
To: dakota-truck@dakota-truck.net
Subject: Re: DML: RE: 408, Bill...HELP!
On Sat, 2 Oct 2004 07:43:12 -0400, James Calder <jcalder3@cfl.rr.com> wrote:
>
>
> OK Bill, I know you have a wealth of knowledge in your head regarding
> the 408! I would be asking Marty himself but he so hard to get a hold
> of. I considered buying a short or long block from KRC but I need to
> keep the cost down (it's the only way I'll be able to afford it), but
> I still would like to get some of the parts from KRC, especially if I need
ported R/T heads.
> If you have any suggestions on the questions below, I would appreciate it!
Not to cast a shadow on the KRC lovin' around here, but have you contacted
Fastman? http://www.thefastman.com/index.asp
This archive was generated by hypermail 2b29 : Mon Nov 01 2004 - 10:47:41 EST