Gary Hedlin <garyhedlin@sbcglobal.net> wrote:
: On 2/22/05 4:35 PM, in article
: 6.2.0.14.0.20050222172911.02f76a10@pop3.norton.antivirus, "Bob Tom"
: <tigers@bserv.com> wrote:
:> Just cut it into small pieces. Jon has a welder :-)
:-) Sure, and if I run out of wire, plenty of duct tape! ;-)
: Jon wouldn't happen to have a 3" tubing bender too??? :)
No, but I do have a 3" tubing crimper! Does that count? :-)
(Mandrel bends are overrated - what you need are 90 degree crimps!)
At least, that's the philosophy of whoever invented the so called
"tubing bender", near as I can figure. ;-)
--
-Jon-
.-- Jon Steiger ---- jon@dakota-truck.net or jon@jonsteiger.com --.
| 1970 Barracuda - 1990 Dakota 'vert - 1992 Ram 4x4 - 1996 Dakota |
| 1996 Intruder 1400 - 1996 Kolb FireFly - 2001 Ram QC 3500 CTD |
`------------------------------------ http://www.jonsteiger.com --'
This archive was generated by hypermail 2b29 : Tue Mar 01 2005 - 10:04:31 EST