Well here's the deal...the 46RH/RE only has 2 points to take up endplay so
some movement of the output shaft is to be expected. Yours is a bit much but
then again I have seen a lot worse.
- Bernd
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Dan Kramarsky
Sent: Wednesday, June 08, 2005 11:09 PM
To: dakota-truck@dakota-truck.net
Subject: DML: 46RH Output Shafts.....
Not sure how many of you have actually grabbed the output shaft on 46RH,
but...
Is there supposed to be any play in the output shaft if you push/pull on the
yoke?
I'm getting like .070" to .100" in play if you look at the movement of the
yoke.
If this amount is too much play, what exactly in the OD section is going
bad?
thanks in advance!
-dan
Dan K.
'92 Grey Dak CC, 318, 4x2, 46RH, 3.55 rear, 235/75R15, PS, PW, PB, PL, AC.
Mods: Cool air, K&N oil/air, Autolite 3924s, re-located IAT.
Future: Swap motor for a slightly modified Magnum 5.9L engine.
__________________________________
Discover Yahoo!
Use Yahoo! to plan a weekend, have fun online and more. Check it out!
http://discover.yahoo.com/
This archive was generated by hypermail 2b29 : Fri Jul 01 2005 - 09:48:06 EDT