Terrible Tom <SilverEightynine@aol.com> wrote:
: So basically what would need to be done, is to determine the voltage
: range that the two sending units operate at and see if they are the
: same. Hmm...
Yep. Well, technically you'd be checking the resistance range
(in Ohms), but yeah, as long as both senders work within the same
Ohm range and in the same direction (i.e. is empty the high
resistance value or low?), then either one should work with the
gauge. If they aren't the same, you could possibly adapt the
existing sender to work in the new tank.
--
-Jon-
.- Jon Steiger -- jon@dakota-truck.net or jon@jonsteiger.com -.
| '96 Kolb Firefly, '96 Suzuki Intruder, Miscellaneous Mopars |
`-------------------------------- http://www.jonsteiger.com --'
This archive was generated by hypermail 2b29 : Fri Dec 01 2006 - 10:33:47 EST