P0700 is a transmission issue code (PCM's way of telling you to check the
trans codes). What's the fluid level at when the engine/trans are at normal
operating temp?
- Bernd
-----Original Message-----
From: Don [mailto:y2kota@y2kota.us]
Sent: Tuesday, April 17, 2007 7:49 AM
To: dakota-truck@dakota-truck.net
Subject: Re: DML: RE: Stalling 4.7L, auto
Opps, too late, set it back to stock this morning before I left work to
go to home. Forgot to mention, it did throw a code the first time it
did happen, a P-0700. It read as some informational code that i never
looked into any further. I forgot about it. I didn't do it on the way
home. about 4 red lights in 2.5 miles.
-- *------------------------------Y2KOTA------------------------------* Don Mallett Y2K QC 4.7L Auto SLT+ 4x2 http://www.y2kota.us *-----I'm not late! It's that the rest of the world is early!!-----*On Apr 17, 2007, at 6:04 AM, Bernd D. Ratsch wrote:
> > > If you're going to look at any type of data (DRB or other > scanner)...which > would be helpful...don't set anything back to stock just yet. Get the > data > and then put it back. However, this leaves you with another > dilemma...returning it to stock will either clear out the PCM's > adaptive > memory ("chip" programmer) or will distort the actual adaptives left > in > memory (removing a "chip"). > > That is one of the signs of a converter going out...but not > necessarily the > problem at hand. Without looking at the PCM data, it's hard to say > what it > is wihout just guessing. > > - Bernd > > -----Original Message----- > From: Mallett, Donald B [mailto:Donald.Mallett@BNSF.com] > Sent: Tuesday, April 17, 2007 1:07 AM > To: dakota-truck@dakota-truck.net > Subject: DML: Stalling 4.7L, auto > > > Lately with my 2000 4.7L auto with 98,200 miles, when stopping the > truck > will stall. Not all the time but about one time out of say 30 times. > It seem > that the tranny dose not want to come out of gear and stalls the > engine. > I've also noticed that the engine is pulling harder on the tranny when > this > happens, guess its just trying to keep up the RPMs. Sometime it > wouldn't > stall but the engine is still pulling harder. I did do a TransGO shift > kit > to the tranny about 4K miles ago. Also have a SuperTuner Chip > installed, The > stalling was taken place when it was set to the "towing" and the "87 > octane". I haven't returned it to stock yet, I'll do that this morning > and > see what happens. No other work was done to the engine shortly before > the > stalling started. ATF and filters have been changed at 40K, 70K and at > 9540 > miles. Any thoughts? > > I hate to ask, what are the signs that the torque converter is on its > way > out? > > > - -- > *------------------------------Y2KOTA------------------------------* > Don Mallett > Y2K QC 4.7L Auto SLT+ 4x2 > http://www.y2kota.us > *-----I'm not late! It's that the rest of the world is early!!-----* > > >
This archive was generated by hypermail 2b29 : Mon May 07 2007 - 19:04:35 EDT