I am having almost the same problem exept my dack 2wd v8 extended heater
will olny work on high.. I guess I will have to find where that board
goes on mine....
David Gersic wrote:
> Heater motor stopped having any working speeds except High yesterday. Searched
> the archives, found that this is usually the motor resistor board. Stopped at
> the local dealer over lunch today and picked up a new one.
>
> Looked up the info in the archives on replacing this. It's wrong for my truck
> ('01 4x4 V6 extended cab). The archives say it's in an access hole under the
> cowl, remove the wiper arms, etc.. It's not. On mine, it's in the passenger
> side footwell.
>
> Would have been a 10 minute replacement if I'd known that. Instead, I just
> wasted three hours pulling the wipers and cowl off, hunting around in there
> with a flashlight and mirror looking for this thing, and putting it all
> together again.
>
> The new one (made in Slovenia) looks like a completely different design from
> the original. Cost me $18. Hopefully the new design is less failure prone.
>
>
>
This archive was generated by hypermail 2b29 : Tue Jan 01 2008 - 00:38:35 EST