I dunno, it kind of sounds like fun! Maybe we could try some fruit too!! lol!
----- Original Message ----
From: Brian <hskr@cox.net>
To: dakota-truck@dakota-truck.net
Sent: Wednesday, June 3, 2009 8:13:25 PM
Subject: DML: RE: RE: RE: RE: RE: Hot Hot Hot
Pretty much what OP is describing. Which is why I said to check the way I
described, because if it isn't harder to turn, then as you said, it is bad.
No need to have the motor running and shove cardboard or newspaper into the
fan.
brian cropp
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Bernd D.
Ratsch
Sent: Wednesday, June 03, 2009 3:15 PM
To: dakota-truck@dakota-truck.net
Subject: DML: RE: RE: RE: RE: Hot Hot Hot
If it's broken, it depends on what happened internally. They can either
seize internally (making it harder to turn or locked up) or break internally
where it will be very easy to spin. I have an '01 Dakota sitting in my
stall with a broken (internally) clutch fan. I can spin it with one finger
and the engine IS at operating temp. Customer complaint: running hot and
A/C not cooling properly.
- Bernd
-----Original Message-----
From: Brian [mailto:hskr@cox.net]
Sent: Wednesday, June 03, 2009 2:58 PM
To: dakota-truck@dakota-truck.net
Subject: DML: RE: RE: RE: Hot Hot Hot
Whether it's fully "engaged" or not, it WILL be harder to spin when the
engine is at operating temps than when it's cold. No ifs, ands, or buts,
about it. Been there done that. On my old '99 R/T I had, anytime you were
driving in traffic with the A/C on, the clutch fan would always engage and
you could hear it roar pretty good. But like I also said, there is a way to
"test" it even when cold by checking how far it spins.
bri
- cropp
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Ray Block
Sent: Monday, June 01, 2009 7:12 PM
To: dakota-truck@dakota-truck.net
Subject: DML: RE: RE: Hot Hot Hot
> -----Original Message-----
> From: Brian
>
> Check your clutch fan to make sure it's engaging. It's easy and, the
> best part, FREE to check. Get the engine up to operating temps to
> where the fan clutch should be engaged,
>
> brian cropp
No offence Brian, but the fan clutch should not be "engaged" at "normal"
operating temps. It should always move relatively easily (although not
necessarily what you might call a "spin") until the radiator temp it senses
is high enough to basically lock it up to where there is little to no easy
turning of it by hand. I'd have to look in my FSM to tell you exactly
what temp that might be but in all my years of experience my fan has only
"engaged" (I could hear the roar clearly) when sitting at a traffic light in
95 degree temps with the AC on.
Just my .02.
Ray
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.339 / Virus Database: 270.12.50/2150 - Release Date: 06/02/09
06:47:00
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.339 / Virus Database: 270.12.52/2152 - Release Date: 06/03/09
05:53:00
This archive was generated by hypermail 2b29 : Wed Jul 01 2009 - 14:24:03 EDT