Thanks all for responding to my question about the screws holding the horn
for my alarm system. I think that I'll probably use a combination of all
the ideas I received, I'll use stainless steel button-head machine screws,
stainless steel washers, self-locking stainless nuts, and some silicone to
seal the holes.... One other question, these sheet metal screws that are
currently in my wheelwell, they're not actually grounding the system, are
they?? I don't have to worry about shorting out the alarm if I use the
stainless hardware, and some silicone?? Jim Mcbride had mentioned something
about using a penny as an anode, what's the benefit / significance here??
Ciao!
Ned Vogler | ----------------------------
Network Administrator | _ _ _ _ _ _
Rockville General Hospital | |_` |_` _ |_| |_| |_ |_| |_`
(nvogler@rghosp.chime.org) | ,_| | | | |_ |\ ,_|
'96 Dakota SLT V8 5-sp 4x4 Club Cab |
'84 Nighthawk 650 '85 Honda XR-350R | ----------------------------
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:21 EDT