Hi Ed;
The codes I have reference to are from the '97 service manual, but should
be the same for your truck.
37** torque converter clutch solenoid/trans relay circuits
37** trans 3-4 shift solenoid/trans relay circuits
37** P/N switch stuck in park or in gear
37 Governor pressure not equal to target @ 15-20 psi
or Governor pressure above 3 psi in gear with 0 mph
37* torque converter clutch, no RPM drop at lockup
37** 3-4 shift solenoid, no RPM drop @ 3-4 shift
37** Governor pressure solenoid control/trans relay control circuit
* check engine lamp (MIL) will not illuminate if this Diag. Trouble Code
was recorded.
** check engine lamp will illuminate during engine operation if this DTC
was recorded.
Man!, you picked a good one. ;-)
Hope this helps.
===================='97 Dakota SLT+=====================
L. John Morris<ljohn@alltel.net>
!!!!! ... your local *HEMI* owner ...!!!!!
White/Driftwood/CC/4x4/5.2L/5spd/3.92SG/air by 'Meldrum'
*Gibson* cat-back
==================== Reply Separator ====================
----------
> From: Weingart, Ed <ed.weingart@attws.com>
> To: 'Dakota' <dakota@ait.fredonia.edu>
> Subject: Computer Codes
> Date: Tuesday, June 17, 1997 11:22 AM
>
> >
> >
> >I have a 1994 Red Extended Cab, 4x4, 318 cid engine and the Mopar
> >performance computer and exhaust. I have a question regarding the
computer
> >code readout. The computer has been showing a 1-2 and a 3-7 for the
past 3
> >months. The truck runs well and the battery has not been disconnected
for
> >the past 50 key starts. I can not find any reference to a 3-7. Can
anyone
> >help?
> Ed Weingart
> >Hampstead, NC
> >
> >
> >
> >
> >
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:44 EDT