At 04:28 PM 7/15/97 -0400, you wrote:
>ok.....i have tbi and dremel tool in hand.........and am taking out the
>throttle shaft........now what......make the whole thing even with the
>center??
>
>Russ
>
Just remove enough to bring the top part of the bore flush with the lower,
polished portion. You're just looking to remove the ridge and open the
bore to a consistant diameter. Your lower portion is probably around 41 or
42mm.
*******************************97 Dakota Sport*******************************
sean meldrum
email: Home: spm@c3net.net (list subscription)
Work: sean_p_meldrum@auto.ittind.com
Homepage: http://www.geocities.com/MotorCity/Downs/7875/
Black, 318, 5spd, 3.55SG, reg. cab, 2wd, buckets
"Fresh air by Meldrum"
All exterior vinyl graphics removed
Moroso Blue Max plug wires and Spectre looms
DynoMax Race Magnum Welded. 3" in/out, exiting before axle.
MSD 6A & Blaster 2 coil w/ chrome cover
****************************************************************************
****
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:48 EDT