At 10:11 PM 9/28/97 -0600, jaallis wrote:
>Hi Gregg,
> I located a source for a fiberglass cowl induction hood for 91-96
Dakota's.
>They use factory hinges and latches. The hoods are Cormat reinforced and
I was
>told you could sit on it and not damage them. They run $389.00 plus shipping
>from Florida.
>The company is:
> US Body Source
> (352)468-2203
>
>The cowl is approxiamately 2.75 inches tall.
>
Do you know if painting is required, or do they come matched and
clearcoated? Any pictures of 'em anywhere?
The thing I'd worry about most with something like this would be
the paint match with the rest of the truck. It would look pretty dumb
if it was even a little bit off, I should think. Also, I wonder if the
fiberglass flexes at all during driving?
Do you suppose the cowl will allow for a taller K&N element?
Yeah, I suppose I could just call the company, but this is much more
fun! ;-)
(I also hate telephones.) :-)
-Jon-
.--- stei0302@cs.fredonia.edu -- http://www.cs.fredonia.edu/~stei0302/ ---.
| DoD# 1038, EAA# 518210, NMA# 117376, USUA# A46209, KotWitDoDFAQ, RP-SEL |
| '96 Dodge Dakota v8 SLT Club Cab, '96 Kolb FireFly 447 (#FF019) |
`-------------------------------------------------------------------------'
I do not speak for the SUNY College at Fredonia; any opinions are my own.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:53 EDT