>> > My problem is the cheeseball PCV fitting they supply with the can.
>
>> I enlarged the knockout hole and used the grommet and fitting from the
>> factory filter housing.
>
> Thanks for the info. Now that you mention it, this should have been
>obvious. I was actually going to remove material from the grommet,
>but this should be a little easier. Plus, it gives me an excuse to
>buy a new tool ;) .
>
> Any problems with oil in the throttle body? One nice thing about
>the factory can is that it runs the PCV fumes through the element.
>
> Thanks again, Noel.
>
> Ron
No problem with oil... After 20,000 miles, my base has a slight dark
stain, but it doesn't even feel oily.
Good luck!! Rob Robinson
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:54 EDT