Now, my stripe goes straight down the quarter panel, but curves up the door before
starting again on the side of the bed. Is it possible to do it yourself and make
a curve? What about more than just lines like = such as coming to a point at the
end?Thanks for the info.
> the method i used to get a straight line was to wrap it around the edge (i.e.
> front of the bed) then have my helper hold it while i walked to the back of
> the truck unrolling the tape and keeping it pretty tight, then just slowly
> lay it against the truck where you want it to finish. go back to your
> starting point and press it against the truck. and here are my last two tips:
> 1. whenever possible have the ends wrap around something
> 2. use a dot of clear nail polish to "seal" the ends of the tape to the truck.
>
> Cuervo
>
> At 08:49 PM 3/15/98 -0600, you wrote:
> >Seeing as I'm going to randomly paint things in my engine Hemi orange, I
> >got to thinking it would be cool to have that w/ orange pinstriping.
> >Any suggestions? How hard is it to put on your own pinstriping, or
> >should I just play it safe and have someone do it who's a pro? How much
> >should I expect to pay?
> >Thanks again,
> >Robert Trottmann
> >
> >--
> >Mailto:rotrottmann@davidson.edu
> >http://thelma.davidson.edu/rotrottmann/web/default.htm
> >Davidson, NC- Now
> >St. Louis, MO- May 19th
> >95 Sport 318 Auto 2WD
> >
> >
> >
--
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:24 EDT