Sounds good! I already have the lifters and springs and I should be able to swing
the cam
soon. I may do the new MP intake that's pre drilled for the injectors also. Good
luck and keep us posted
Andre
Rekker21@aol.com wrote:
> In a message dated 98-07-06 09:26:35 EDT, you write:
>
> << I have a 95 reg cab short bed 5spd. It runs 14.70@94.5mph with the
> following mods
> MP SBEC
> Hi-Po exhaust from manifolds back
> March Pulleys 180 thermostat
> K&N FIPK
>
> My objective is mid to low 13s, so I plan the following:
> Crane 2030 Cam
> Head porting
> Throttle body mods
> Intake mods
> Headers
> Install 9 1/4 rear end
> Andre Mauboussin
> >>
> Hey man, you have the same Dak as me, except I swopped engines. When I had
> the 5.2 in it I was runnin 14.70's too with pretty much the same mods as you.
> Low 13's are what Im shooting for too, but all the internal work will be the
> cam and lifter setup. Good luck
> Eric........14.29@95.17============================================
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:04 EDT