Thanks. Can just about any competent machine shop do this (bore the
ports)? Did you use different blades? looks like you'd have to if you
did more than a polish job.
Tate
-----Original Message-----
From: Rekker21@aol.com [SMTP:Rekker21@aol.com]
Sent: Friday, July 10, 1998 10:49 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: Throttle body coating???
In a message dated 98-07-10 07:48:51 EDT, you write:
<< Any other suggestions on dos and don'ts
for this project? >>
Tate, just remember that if you bore out the ports your R's at an
idle will
go up a little. Both of the ones I did have, but it doesnt really
isnt a
problem.
Eric
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:04 EDT