At 03:35 PM 7/10/98 -0700, you wrote:
>If you're talking about the element top, I saw one right after they
>came out at the k&n trailer at the Texas Motorplex in May - weren't
>even in anyone's k&n catalog yet. They looked great and I had always
>wondered why no one had produced one - they look very practical and
>you could overcome any clearance problems you might have by going to
>one of these lids on a smaller height/diameter filter. Look cool too
>IMO. If I chose to go with an element on top of the throttle body
>versus a tube setup, I'll damn sure have one.
>
I called Summit today to order one but they said it was on
manufacturer's hold. Apparently the top isn't rigid enough and it was
collapsing. Anyone know anything about this?
-Jon-
.--- stei0302@cs.fredonia.edu ------------------------------------.
| Affiliations: DoD, EAA, MP Race Team, NMA, SPA, USUA. RP-SEL |
| '96 Dodge Dakota v8 SLT CC (14.98@90.18), '96 Kolb FireFly 447 |
`----------------------- http://www.cs.fredonia.edu/~stei0302/ ---'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:05 EDT