At 03:29 PM 7/19/98 -0400, you wrote:
>In a message dated 98-07-18 20:49:37 EDT, you write:
>
><< Have mine set level at rest, and set the snubbers 1/2" off the spring. Had
>to
> build shims for the rear bracket. Then shoved them up against the axle
>bracket
> george >>
>
>Same thing I did with mine..
>
Anyone know what a good distance is from the snubber to the leaf?
How important is it? I immagine if its too far away, the effectiveness
will be diminished, but what if it's too close? (is there such a thing?)
Also, should the right snubber be the same distance away from the leaf
as the left snubber? My left snubber is a little closer than the right
one. I suppose I could shim the right one up a bit, but why would there
be a difference in the first place? Bent axle? :-(
-Jon-
.--- stei0302@cs.fredonia.edu ------------------------------------.
| Affiliations: DoD, EAA, MP Race Team, NMA, SPA, USUA. RP-SEL |
| '96 Dodge Dakota v8 SLT CC (14.98@90.18), '96 Kolb FireFly 447 |
`----------------------- http://www.cs.fredonia.edu/~stei0302/ ---'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:07 EDT