You can clear error codes, but not reprogram things such as speedo
calibration, timing, door locks, etc. The CarComp also can store and display
real-time plots of sensors vs rpm vs road speed, etc.
And without an external scan tool of some sort, there is no known method for
retrieving codes from 98's. The ON-OFF-ON-OFF-ON method only works with pre
98 models.
gk
________________________________________________________________________
Gary E. Klim - Somewhere In Connecticut mailto:garyklim@snet.net
http://pages.cthome.net/garyklim/ mailto:gklim@harman.com
________________________________________________________________________
> -----Original Message-----
> From: owner-dakota-truck@buffnet4.buffnet.net
> [mailto:owner-dakota-truck@buffnet4.buffnet.net]On Behalf Of Mike
> Crumley
> Sent: Friday, September 04, 1998 1:15 PM
> To: dakota-truck@buffnet.net
> Subject: Re: DML: RE: Scan Tools
>
>
> At 06:58 PM 9/3/98 , you wrote:
>
> >Although there's no programming capability with the CarComp, it's $1,450
> >less than the D.A.R.T. Scan Tool. Gee, now I can get a laptop AND have a
> >scan tool... :-)
>
> So if there's no programming capability, then for $1450 you get
> to see on a
> laptop screen what you can see for free on your dash using the
> on-off-on-off-on method.
>
> --
> Mike Crumley mcrumley@airmail.net
> 97 RC 3.9L V6 3.55 Auto Rhino Liner
> Bug Shield Mud Flaps DDBC
>
> Childrens Book Titles You'll Never See--
> "You're Different...And That's Bad"
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:45 EDT