The ones from BellTech (sp) are parallel.
I do have a suggestion - either plan on pulling them off and taking
some material off of them, or make them 1 1/2" tall in the first
place. Myself and other members have noted that two inches is too
much for some of our trucks - drops the ass a little too much.
Tate
-----Original Message-----
From: bnich@bellatlantic.net [SMTP:bnich@bellatlantic.net]
Sent: Monday, September 07, 1998 8:14 PM
To: dakota-truck@buffnet.net
Subject: DML: Lowering the rear only
I'd like to level out my truck it seems like the rear is 2" higher
than
the front. Anybody done this yet. Can I do it with Blocks? I hear the
alum.
ones are NG. I have a machine shop so I could make a pair out of
plate.
Any one know if they are paralell or have an angle? Thanks again Bob
-----------------------------------------------------------------------
---------
(__) ,---------. NOTE: The preceding message was sent via
Jaek and
(oo) | :\/: _ _ \ Jon's WWW mail cow gateway. That is to
say, the
/-------\/_/ : :: :: : ) person who sent this message could in
fact be an
/ | MAIL|| \_ ' '`-'`-'/ anonymous prankster. Even though this
message was
* ||"" || \__________/ mailed to you from the cs.fredonia.edu
domain, it
^^ ^^ could have been generated by anyone in the
world.
Please keep this in mind. Thank you! --Jaek (smit2204) and -Jon-
(stei0302)
-----------------------------------------------------------------------
---------
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:47 EDT