If I remember correctly, these injectors are made by Siemens. I do not have
my reference literature with me, but if no one comes back with a part number
prior to tomorrow, I will give it to you. I will have the delivery rate as
well. They are supposedly available, straight across the Ford counter.
(Man, that leaves a nasty taste in your mouth!) Remember, this part is
manufactured by Siemems. They are a drop-in replacement.
Rich - Ashburn, VA
-----Original Message-----
From: Rekker21@aol.com [mailto:Rekker21@aol.com]
Sent: Wednesday, October 07, 1998 5:27 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: HI FLO Injectors
In a message dated 10/6/98 11:41:57 PM Eastern Daylight Time,
mike@snakebite.com writes:
<<
Ok you've got our attention now, so give us the details on them like size
and
stuff... Do you think
these would help the pinging with the MP SBEC? I've been thinking
about new injectors myself....
>>
Hm, good question. Im not sure if it would help pinging or not! It very
well
may though! I never thought of that.
They look the same size, but if you look at the bottom where the fuel is
discharged instead of there being only one small hole like on our stock
ones,
there are four little holes! 75% more! Im not saying you're getting 75%
more
fuel, but you have that many more holes which if nothing else helps atomize
the fuel on discharge. Ill come clean too! The rumor that the Cobra
injectors, which are hiflo, are a direct fit for ours, may well be true!
These injectors have that hemhem, ford insignia on them! HEY< ITS NOT MY
FAULT!!!!!
Eric
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:10:34 EDT