Ok, thanks Kyle. I can't believe I didn't see all these fittings when I
was under the truck... Is any high quality grease acceptable?? I forget
what I loaded into the grease gun at this point, but I'm sure it was a high
quality synthetic.
T.
______________________________ Reply Separator _________________________________
Subject: Re: DML: Lubricate the Steering Linkage
Author: <dakota-truck@buffnet.net> at smtpout
Date: 12/29/98 1:17 PM
On my 93 Dakota 4x4 here is what I hook the grease gun up to about every other
oil change:
***Idler Arm has one fitting....I just put a new one on this weekend and the
aftermarket one has 2 fittings. The old one was shot, worn out, where the new
one has an additional grease fitting.
***Pitman Arm has 1 fitting
***Tie rods have 2 fittings, per side
***Upper and Lower ball Joints
***Front driveshaft
***Rear driveshaft
I think this is it! Let me know if I missed anything.
Kyle
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:33 EDT