Tom
You can get a voltage test light to test spark plug wire conductivity. It
looks like a screwdriver, but just tells you if the wire is good at idle.
When you reset your computer, did you do it by removing the pos. terminal on
your battery or by unplugging the wire harness at the computer. If you did it
at the wire harness, you may want to check the connection. Lube it up with
dielectric grease too.
Are you getting any fault codes from the comp?
Hope this helps
Boog
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:13 EDT