For my 93 I used #20, #25 and #30 torx drivers. There's a listing of the
tools needed in for the install and the #20 torx is in there but I needed
the other two to get everything off on my 93. Besides that all you need is
a 5/16" box wrench, a 1/2" socket and a 3/16" allen wrench. I went out and
bought the torx drivers for around 3 bucks each at western auto.
Chris
-----Original Message-----
From: Patrick Delgado <dadoctah@worldnet.att.net>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Friday, February 12, 1999 4:52 PM
Subject: Re: DML: Finally installed my TB
>Torx drivers? oh-oh. I had planned on installing mine in the post office
>parking lot when it came in.
>What tools are needed for the B&F TB R&R?
>Dr. Pat
>
>----------
>>From: Chris lang <langcj@clarkson.edu>
>>To: dakota-truck@buffnet.net
>>Subject: DML: Finally installed my TB
>>Date: Fri, Feb 12, 1999, 8:46 PM
>>
>
>> It was somewhat warm outside today so I decided it was time to finally
>> install my B&F TB. After getting the right size torx drivers the install
>> went without a hitch and was quite easy, thanks to the instructions from
>> bruce. Since it started raining during the install I didn't get a very
>> good test drive in but there was still a noticible difference in the
>> throttle response. I can't wait till the roads dry a bit to really punch
it
>> to see what I've got. Thanks again Bruce and Frank, you get my TB in the
>> mail in a few days along with my check. I'll try to clean it up a little
>> before sending it since its looking a little nasty at the moment...
>>
>> Chris
>>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:35 EDT