In a message dated 99-02-17 11:58:28 EST, you write:
<< I would have one made up custom only if the shop is able to mandrel bend
the
tubing without crimping it. If they cant, find a place that can or buy a
set that is mandrel bent. No magic, but smooth bends are a must! 2.5"
diameter is a little big on a 318 to maintain bottom end torque...Even on a
non magnum smallblock... >>
Are there any gains on replacing this pipe on a V6? Just to make sure, is the
Y pipe just the pipe that connects the both of the exhaust manifolds and comes
down into one pipe before the cat? What size is the stock y pipes? What size
would be better to go with? Just curious, thanks.
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:37 EDT