kool, I will look during lunch time....
Jason
2/19/99 11:03 AM
-----Original Message-----
From: Jetmugg@aol.com [SMTP:Jetmugg@aol.com]
Sent: Friday, February 19, 1999 10:04 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: RE: Re: mopar wires
Jason:
The tool is actually two pieces of steel, one of which
clamps into a bench
vise, and the other piece which you hit with a hammer. When the
two pieces
are together, there is an opening in the center of them which is
only slightly
smaller than the diameter of the plug wires themselves.
Again, the "lower" piece fits in a vise, then you put
the plug wire, with the
core folded back, and the connector on the wire, onto the lower
piece. Then
you put the upper piece on top of the lower, and hit it with a
hammer, thus
crimping the connection. I believe they are available from
Summit and Jeg's,
if you want to see a picture of one.
Steve.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:38 EDT