Uhhh....You sure? When I pulled my deck out (The AM/FM - CD/Tape "High End
Unit"), there wasn't anything behind the kick panels...let alone the dash.
Just one BIG unit. I know there's nothing behind the kick panels since I
removed them and ran new 12ga. wire to the new speakers. (Beats the cheesy
16-18ga. thread Dodge used.)
> Right side behind the kick panel......don't run the remote from there run
it
> from the dash.....easier to get to and maintain. On the 7 wire connector
it
> is the blue wire (I think) the #1 position.
>
>
>
> Do you know where the infinity amp is located? Under dash? Or ?
>
> Thanks
>
> Dak99RT@aol.com wrote:
>
> > <<That's kinda what we did. Tapped into the rear speaker...a wire from
> each
> > side....then into a line level converter....and then to the amp??? Also
> > when ever I flip on the power a loud pop erupts when it gets to the
> > amp...any ideas or is this just because my stereo doesn't have RCA
> outputs?
> > Thanks!>>
> >
> > This is because your amp is turning on before your radio. Try running
your
> > remote wire from the amp to the radio's remote output instead of where
you
> > have it now. If you have the Infinity factory amp, it is the green wire
> with
> > the red stripe going into one of the amps wiring harnesses. I tapped
into
> > this wire and my amp no longer make the annoying turn on/off thump/pop.
I
> had
> > it running into the fusebox before the fix.
> > Hope this helps,
> > Charles
> > 99 Dak R/T
> > Ps. I too have a line level converter.
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:06 EDT