I wrote this letter to MSD, but am curious if my fellow DMLers can help me
out once again:
I own a 1993 Dodge Dakota 4x4 V6 which I am attempting to hookup your PN6470
6-Offroad box into. I have also purchased the universal wiring harness 8873.
I have the box mounted in my engine bay and have spliced in 4 feet of
power(red) and 4 feet of negative(black) 10 guage wire. I am lost concerning
installing this into my stock ignition system. What do I do with the wiring
harness and the smaller harnessed which came with the box??? For the smaller
harnesses I have a 2 red wire harness with a blue connector, a 2 white wire
harness with a blue connector and a single black wire with a ring terminal at
one end and a red connector at the other. Also I have a green/purple harness
with a black connect at each end as well as a orange/black harness with a
black connector at the end and ring terminals at the other; these 2 harness
appear to plug into the larger harness. The large harness I can describe as
starting out it seems to have a large black connector which seems to plug
into the 6-Offroad box itself marked with A(red), B(orange), C(black),
D(purple), E(green), and F(white). From this 6 wire connector, 2 wires( red
and white) have nothing attached to them at the other end. The orange/black
are together with a connectors and the green/purple are together with a
connector. Attached to this large harness is a gray wire with a connector at
one end and nothing at the other. How does the 8873 universal wiring harness
get connected into MSD's wires and my stock ignition system??? What or how do
I go about using the box into my stock ignition system??? Does this ignition
box get plugged into/tapped into my distributor or anything else, other than
my coil??? THANKS for any and all help with this.
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:22 EDT