Cool! Glad to see ya got it!
Eric
mh wrote:
>
>
> A mind is a terrible thing to waste - mine kicked in after some coffee.
>
> If I had just paid attention the first time I looked at the wiring diagram
> I would have seen the clues, enough to make some deductions anyway. There
> are three wires going to the sensor, looking at the wiring diagram two of
> these are also wired to several more sensors in paralle. Duh, power and
> ground! Mr Fluke says the blue/black is ground and the orange supplies
> 8.8VDC from the control module. Getting a little over 2 ohms between pwr
> and ground. No way a sensor is going to draw 4 amps. Cut the wire ties and
> find the culprit, three wire ribbon in a horizontal plane suddenly
> contorted to the vertical in the space of an eight of an inch and the ribs
> are no longer visible. I carefully sliced between the ribs, one wire will
> need a splice the other two can be wrapped. Now all I hafta do is stand on
> my head with a soldering iron, some solder and some heat shrink.
>
> Doc
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:51 EDT