Andre:
I've got a '95 FSM but I don't have access to a scanner. Do you have a
fax number that I can fax these pages to?
Better yet, come on down so I can watch! ;^)
Richard in SA
On Sat, 10 Jul 1999 09:27:35 -0500 Andre Mauboussin <andrem@ticnet.com>
writes:
>Hello again everyone;
>Sorry I've been so quiet on the list lately. I finally got a message
>from Dave Hughes of Hughes engines that my stage one ported heads,
>custom ground cam and timing set should ship this week(cam has the
>following specs .512in .527ex duration 215in 220ex. lobe separation
>112deg) The heads have special springs/lock/retainer set-up and are
>quite a bit beefier than the MP set. Also, the B&F Stage II throttle
>body should be here in a matter of days. These parts installed along
>with some intake mods should spell certain doom for local Mudstains,
>the
>new Lightning, ram-air Batmobiles and unsuspecting corvettes. I've
>have
>waited long enough, soon the beatings will begin ;-). My performance
>objective is mid to low 13s. I am in need of the factory service
>manual
>(I've been told distributor line up can be a pain on the magnum
>engine).
>I guess I will have to order one unless someone can send me the
>section
>on cam R&R. I would appreciate any tips any of you may have on the
>cam
>installation or anything regarding my proposed changes. I'm delighted
>to
>read all the messages about everyone improving the performance of
>their
>trucks to include all the latest parts and tricks. Best wishes to
>all.
>
>PS Alan, did you make it to the night of fire(I couldn't)?
>Andre
>
>95 Dak Sport Reg cab SB 318 5spd 3:90 Sure Grip
>14.5-14.60(Estimated. Truck ran consistent 14.7 before JBA header
>install)
>
___________________________________________________________________
Get the Internet just the way you want it.
Free software, free e-mail, and free Internet access for a month!
Try Juno Web: http://dl.www.juno.com/dynoget/tagj.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:56 EDT