Guys,
In the article you're talking about, they put magnum heads on an older,
flat-tappet cam, small block. They had to use AMC lifters and hollow
pushrods to oil the valvetrain... thats it. They heads bolted on other than
that.
The '91 360, however, already has the roller cam. It's essentially the
same block as the magnums. All you would have to do is bolt the magnum heads
on and go. You may also have to use magnum lifters as I'm not sure the '91
rollers will oil through the pushrods.
Doug
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:03 EDT