Thanks, Rich. That's the same information that I had.
At 08:40 AM 8/14/99 -0700, you wrote:
>Bob,
>If it is where the fuel line connects to the fuel rail, there is a special
>fitting tool to disengage the "fingers" inside the connector. I don't know
>if you can get them apart without the tool. I haven't messed with them yet.
>If it's down under the frame, it may be one of the quick-disconnect type
>connectors. These have a tab you pull out, but not before releasing the tab
>locks on the opposite side of the connector. Otherwise, you'll break it.
>Hope this helps. Maybe not. My knowledge stops with the 1st generation
>DAKS. Catch you later.
>Rich - Ashburn, VA
>
>-----Original Message-----
>From: Bob Tom [mailto:tigers@bserv.com]
>Sent: Saturday, August 14, 1999 6:50 AM
>To: dakota-truck@buffnet.net
>Subject: Re: DML: Powerdyne installed, fuel line
>
>
>At 09:50 AM 7/31/99 EDT, you wrote:
>> Hey Dml'ers how do I get the fuel line to seperate where it connects
>>under the drivers side, from the tank to the fuel rail ?
>>Thanks , Ted O.
>
>Ted
>
>Did you any information on your question? If not, I can send some.
>
>Bob
>Burlington, Ontario
>
>'97 CC Sport, 5.2L, 3.55, auto., 4x2, flame red
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:48 EDT