In a message dated 8/14/99 10:56:42 AM Pacific Daylight Time,
tigers@bserv.com writes:
> If it is where the fuel line connects to the fuel rail, there is a special
> >fitting tool to disengage the "fingers" inside the connector.
I cut the end off of a funnel (3/8" dia), slit it so it would go around
the gas line, push the connector towards the piece of funnel, then pull the
two apart, drain gas etc.
Hope this helps, Ted O.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:48 EDT