Almost forgot....
JBA seems to be the only ones (for now) developing a set of headers for the
V6's.
It may be a couple more months before they are released.
At 11:49 AM 08/19/1999 -0700, you wrote:
>Thanks for the info Bernd,...i'll start checking out those sites mentioned.
>
>
>
>"Bernd D. Ratsch" wrote:
> >
> > Hi Dean....welcome to the DML.
> >
> > There's a lot of mods that you can do to your engine for more power:
> >
> > (1) QuickD makes a good Intake System for the Dakota
> > (http://www.quickd.com) as well as modified Throttle Body (Lots more power
> > for the V6's!)
> > (2) Magnum Performance is another outlet for modifications
> > (http://www.fastdodge.com)
> > (3) Any Aftermarket system is good...Flowmaster, Gibson, Borla are among
> > the top ranking on the DML trucks.
> > (4) An aftermarket ignition system definitely helps as well...MSD Offroad
> > Setup if you like.
> > (5) JET Products makes a very good "Chip" for the Dakota's as well and
> > comes in two flavors (http://www.jetchip.com)
> > (6) A Brass Terminal Cap & Rotor along with a good set of Spark Plugs and
> > Wires (SplitFire, MSD, Magnecore on the wires and SplitFire or Champion
> > Truck Plugs for the Spark.)
> >
> > These are the most common mods that you can do on your V6 without getting
> > into too much work (or cost).
> >
> > Regards,
> >
> > Bernd D. Ratsch
> > Pflugerville, TX
> > http://lonestar.texas.net/~bernd/Dakota.htm
> > 1997 Dodge Dakota SLT/CC (V6)
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:54 EDT