Re: Street and performance - Now TB/Manifold Opening

From: Patrick Delgado (dadoctah@vitelcom.net)
Date: Fri Aug 27 1999 - 13:46:51 EDT


Got it. Didn't realize you had removed floor of manifold.
Dr. Pat
----------
>From: Gary Shook <gary.shook@wcom.com>
>To: dakota-truck@buffnet.net
>Subject: Re: DML: Street and performance - Now TB/Manifold Opening
>Date: Fri, Aug 27, 1999, 4:19 PM
>

> Lets see if my lame attempts at ascii graphics can help-
>
> Option 1: weld a heat shield to the bathtub gasket:
> _/^^^^^\_
> \ open / <-intake, open, relies on bathtub gasket to seal vacuum.
> \______/<- bathtub gasket
> \--------/ <- heat sheild..
> corners bent up & welded to bottom of bathtub gasket
>
> There should be plenty of room below the bathtub gasket to fit the heat
> sheild
>
> Option 2: seal up the bottom of the intake w/ plate aluminum:
> _/^^^^^\_
> \______/ <- Intake w/ bottom sealed up by plate Al
> \______/<- bathtub gasket
>
> Hope this helps...
>
> Gary Shook



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:16:04 EDT