John,
I notched out the base of the loom holder to drop down behind the valve
cover lip.
Rich - Ashburn, VA
-----Original Message-----
From: John Cullen [mailto:cullen@voicenet.com]
Sent: Saturday, September 18, 1999 3:45 PM
To: dakota-truck@buffnet.net
Subject: DML: Wire Looms
Anybody using the vertical Made for You (not your engine) wire looms?
If so, did you a: remove the existing threaded studs and use the
hardware supplied.
b: cut a groove in the nylon holders to
accommodate the lip on
the valve covers or use spacers.
Thanks
John
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:16:55 EDT