RE: 88 3.9 it hesitates when starting to pullout

From: Griffo (griffo@bv.net)
Date: Sun Jan 02 2000 - 12:07:41 EST


Well I have tried all the things you have mentioned. It idles fine.
I have not tried to replace the o2 sensor yet I will do that some time this
week.

Thanks
Mark Griffo
Network Engineer
griffo@bv.net (Home)
griffo@expedient.com (Office)

-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Ramsport96@aol.com
Sent: Sunday, January 02, 2000 11:41 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: 88 3.9 it hesitates when starting to pullout

I suppose you could try resetting the PCM, maybe it doesn't know that you
tuned it up...???? it's probably set in it's ways and needs a reset...
Check all your vacuum connections too..and what the heck replace the timing
chain and tighten intake manifold bolts.. sometimes they back off...
and how about that coil? how old is it?
how does it idle?
just throwin some other stuff at ya maybe something else that maybe hasn't
shown itself out there..
Paul



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:46:24 EDT