Well I had a good time. All the guys at the shop liked my R/T over the camaros
and firechickens. "It's not a dime a dozen" they commented:)
OK here's the hard data! My corrected numbers came out to:
225.3 HP
315.1 ft/lbs
uncorrected was
231.0 HP
no uncorrected torque reading due to error
Last time corrected numbers were:
208.4 HP
289 ft/lbs at the same RPM
Unfortunately I couldn't get any info under 3500 RPM this go around. FYI at
like 3000 RPM my torque was close to 325 ft/lbs last time. So either I moved my
powerband up, or my torque just increased significantly all around.
Overall a good improvement w/ the exhaust and cold air. Not yet where I wantto
be, but not bad none the less. Not too shabby for a truck, although Istill lost
my best to Drew (91 IROC Z28 w/ cam & headers) by about .9HP doh!It was nice to
meet everyone. I'm sorry about those who showed up andcouldn't get squeezed in.
I was originally under the impression that dynotests would continue until about
3 like last time. Next time I'll check it out more closely.
-George
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:47:56 EDT