At 07:17 PM 2/8/2000 -0500, you wrote:
> Has anyone seen the new Summit catalog? They have
> the
>M1 aluminum intake manifold for magnums.=$259.00 What will I need besides
>gaskets to install this? Any fabrication? I plan on doing a bunch of mods
>all at once. Besides the M1 im doing the heads,#24lb injectors, Roller
>rockers, Valve springs,and a cam.
>I currently have a R+D TB, Mopar headers, Flowmaster cat-back, and Gen 2 K+N.
>Here's another question: What cam duration should I use based on all those
>mods?
>should I use the Mp cam-204/208dur? I've heard the magnums need more on the
>exhaust side,maybe a 204/212dur or 204/214dur?
>Thanks for any help!!!!!!!!!!!!!
Can't help you on the intake, but I can give you some suggested cam
profiles. First I need more information: What Dakota is this? (RC/CC),
what size engine? What size tires, what rear end gears, what transmission,
(is converter still stock if automatic?), how big are the primary tubes on
the headers, how big is the exhaust pipe to the cat, how big are the pipes
on the cat-back system?. What size TB? Any cold air intake mods?
Is any porting, port matching intake to heads, or polishing of the
combustion chambers going to be done? Were the headers port matched to the
heads? If not, do you plan to have the headers and heads port matched?
Answer these questions as best you can and I'll figure out some suggested
cam profiles.
Mike Schwall
__________________________
mschwall@flash.net
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:47:57 EDT