Clay,
The connector has internal finger locks on it. If you want to remove it and
not purchase a special tool, here's what I did. I simply took a piece of
cereal box cardboard, cut it, and used it like the tool. You slide the
cardboard (or any other material you choose to make a shim out of) up into
the connector from the rail side. This will disengage the locking fingers
and the connector will slide apart. Simple!
Rich - Ashburn, VA
-----Original Message-----
From: Clay Cooke [mailto:cooke@ecn.purdue.edu]
Sent: Thursday, March 16, 2000 1:37 AM
To: dakota-truck@buffnet.net
Cc: indyram@onelist.com
Subject: DML: Fuel line to fuel rail, HOW TO REMOVE!
Hey all, Im getting ready to install a cam and really dont want to totally
disassemble the MPI intake if I dont have to, so HOW do you remove the
fuel line from the fuel rail?????? Im pretty sure it has some "advanced"
process cause I tried pulling really hard and it wont budge... I imagine
there is some special tool or something right?
Clay
84 Dodge Ram, scrapin pavement w/ 440 8bbl
96 Indy Ram, scrapin EVERYTHING w/ 360 Magnum!' -(www.indyram.org)
69 Road Runner 440 6bbl, project car
http://expert.cc.purdue.edu/~cooke
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:49:46 EDT