Well,
There goes that experiment. I bought a set of proform chevy 3/8 stud
roller rockers. They came in today and
1) they don't fit the dakota.
2) the stock valve cover gasket is rubber, no need to waste 40 bucks on a new
one.
a little disappointed.
I think if I can buy a stud to go in the hole that the BOLT holds the stock
rocker arm to, I can adapt it in there, but the bolt is not 3/8 so it'd have
to be a very special bolt. Anyways. If anyone has any comments or has done
this before. tell me how!!
-Dester
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:10 EDT