Re: Roller rockers- neat update

From: TEDSDAKOTA@aol.com
Date: Fri Apr 07 2000 - 18:01:03 EDT

Next message: Bob Tom: "Re: Pulleys att: Rich"
Previous message: Redmopar99@aol.com: "Re: Dodge & Cops"
Next in thread: Dester223@aol.com: "Re: Roller rockers- neat update"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

In a message dated 4/7/2000 2:58:19 PM Pacific Daylight Time,
ashort@flash.net writes:

<< Be careful not to make the slot too wide or cut it in the wrong place.
It has to be centered right over the adjusting nuts and only wide enough for
the socket to fit easily.
Alan S. >>

Thanks again...

Ted O.

Next message: Bob Tom: "Re: Pulleys att: Rich"
Previous message: Redmopar99@aol.com: "Re: Dodge & Cops"
Next in thread: Dester223@aol.com: "Re: Roller rockers- neat update"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:38 EDT