Ya, one thing is that make sure the two bolt holes when u remove the housing
and clean off the old gasket is clean inside. i scraped off the old stuff and
some fell into the holes and when i put the gasket down line it all up and
start to tighten the bolts start to hang up, i thought i was crossthreading
but I just cleaned the treads out with a tap. other than that there is a
cross brase goin from the manifolt to i thing the alt or the ac pump. get
that outta the way just to make life easer.
Joe
92 5.2 3.55sg
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:40 EDT