Automotive Industry Standard.
(Industrial???)
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Ken
Sent: Saturday, May 20, 2000 9:31 AM
To: dakota-truck@buffnet.net
Subject: RE: DML: Rest of the CPU?
Did you say Industrial standard..
Ken
00 R/T White CC
> -----Original Message-----
> From: owner-dakota-truck@BUFFNET.NET
> [mailto:owner-dakota-truck@BUFFNET.NET]On Behalf Of Bernd D. Ratsch
> Sent: Saturday, May 20, 2000 9:26 AM
> To: dakota-truck@buffnet.net
> Subject: RE: DML: Rest of the CPU?
>
>
> Resetting the computer takes no more than 15 seconds.
>
> Disconnect the NEG post, hold the key in the START position for
> 15 seconds,
> reconnect the battery. This bleeds any residual energy out of the system
> and has been the industry standard on resetting the computer.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> Subject: Re: DML: Rest of the CPU?
>
>
> At 01:02 AM 5/20/00 EDT, you wrote:
> >I know this was talked about before but I can't find it anywhere.
> >I put on the K&N air filter today and the dual exhaust last week
> >on my 00 quad w/4.7L, Does the computer on the 00 dak's record and
> >in turn run the systems by your past driving habits?
>
> Yes.
>
> >and if so with the new exhaust and air filter should this be reset?
>
> I would.
>
> >and if so how?
>
> Disconnect the cable from the negative post of the battery and wait
> about 15-30 minutes before reconnecting. Some say that you can
> bypass the waiting time by turning the ignition key fully
> and holding the key there for about 15 sec. while the neg.
> cable has been disconnected.
>
> Bob
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:21 EDT