At 11:32 AM 5/24/00 -0400, you wrote:
> Anyone running a fuel pressure guage,,What'ja get and how did you
> hook it up..I don't want a gas line in my cab..
> Thanks , Ted O
Ted,
Check out Intellitronix's line of digital fuel pressure gauges. Summit
carries them, and I think some of them are shown at
http://www.intellitronix.com. The sender just screws right on to the
schraeder valve (test port) on your fuel rail, and the only thing going
into the cab is electrical wires. I had to get an elbow to make it fit
under my air hat, but since you have a GenIII you can probably just plunk
it right down onto it vertically. If you take a look at the last pic in
the MPI install manual, or on-line here:
http://www.cs.fredonia.edu/~stei0302/www/dakota/upgrades/mpi/tree1.jpg
You can see the sender at the top of the pic. The one I got displays
the fuel pressure in LED numbers, but I think they have an "analog" version
too. (Its got a needle, but its still digital.) I'm pretty happy with it,
and it wasn't too expensive; I think its about $40.
-Jon-
.--- jon@dakota-truck.net -- or -- stei0302@cs.fredonia.edu ------------.
| Jon Steiger * AOPA, DoD, EAA, MP Race Team, NMA, SPA, USUA * RP-SEL |
| '92 Ram 150 4x4 V8, '96 Dakota V8, '96 Intruder 1400, '96 FireFly 447 |
`---------------------------- http://www.cs.fredonia.edu/~stei0302/ ---'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:24 EDT
