I did this with my 00 Quad W/4.7L and what a show the instrument cluster gave me. the lights danced and the guages also did a little dance. This is something to remember if ever buying a used Dak.
Don Mallett
Fort Worth Tx
geocities.com/maldbnsf
<< Easy... If it's '99 or older cycle the key from off to on 3 times (don't
start) the third time you turn to on it should display a code. then just
cycle off-on again to get the next code. I believe that's how it's done
(never done it just remember the question's been asked before). If it's a
00 you hold the trip button in the instrument cluster while you turn the
ignition on and keep holding until the cluster starts going nuts. (the
guages go through a self test then the codes pop up.) Here's your list of
codes -- http://www.cs.fredonia.edu/~stei0302/www/dakota/CODES/codes.html .
Good luck!
------------------------
Nate, Ogden UT
http://www.geocities.com/natedak2k
Forest Green 00 Dakota CC 4X4, 5-speed, LSD, 3.92 Rear, 4.7L/287ci, Po'boy
cold air w/ K&N, Extang BlackMax Tonneau
"D2K"
----- Original Message -----
From: Gene Rivers <webmaster@mopars.net>
To: DML <dakota-truck@buffnet.net>
Sent: Saturday, June 17, 2000 11:22 AM
Subject: DML: Pulling codes (Gen III)
> OK........how do you pull the codes on a GenIII and does anyone have a
list?
>
> Please cc me in off the list if you can.
>
> Gene & Renee Rivers
> 99 R/T, CC, DA, 95 SLT, RC, CR, 68 Charger 440
> NATIONAL DAKOTA MEET
> http://www.houstonmopars.org
> Sep 23-24, 2000
>
>>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:48 EDT